Sunday, April 28, 2013

Custom order - hammered 15 gauge copper cuff

Just listed a custom order for a customer.....

normally I create my cuffs with 1 mm thick copper sheeting which is 3 cm wide, but
my customer requested 1,5 mm thick and 4 cm wide.

Never used this thickness for a cuff before. It was quite an experience because it
was much studier than the 1 mm one.
I needed much more heat to anneal it and much more power to hammer it (probably will
have sore arm muscles tomorrow :)  )

Here the result:



I like it, I hope my customer does too. 

No comments:

Post a Comment